• Designed exclusively for Harley-Davidson Big Twin and Sportster engines
• Butterfly-type carbs with a fully adjustable idle mixture screw and a changeable mid-range and high speed jet
• Fully adjustable accelerator pump and a variable enrichment/fast idle device for improved throttle response, engine starting and warm-ups
• Super E has a 1 7/8" (47.6mm) throat at the butterfly and a 1 9/16" (39.6mm) venturi and is recommended for use on any displacement Big Twin or Sportster
• Super G has a 2 1/16" (52.3mm) throat at the butterfly and a 1 3/4" (44.5mm) venturi and is recommended for use on 74 cubic inch engines and larger where high performance modifications have been done or are planned (not recommended for smaller, lower compression engines)
• If you are not sure which carburetor to use, we suggest the 1 7/8" Super E
• Each complete carb kit includes: one S&S Super E or Super G gas carburetor, one S&S teardrop air cleaner assembly, one manifold, mounting hardware, fuel line, clamps, overflow line, one extra intermediate jet, two main jets, VOES tubing (when applicable), and installation and jetting instructions
• O-ring style intake
  
  NOTE: Not for models with magneto
  
  NOTE: S&S Super E and G carburetors require the use of a two-cable, pull open-pull closed throttle assembly. If your bike is not equipped with one, a two-cable system must be purchased separately.

(1) Chrome air clearer cover

(1) Air filter

(1) Silver backplate

(1) Chrome fast idle lever

(3) 1/4"-20 x 7/8" Tapered flat head bolts

(3) 1/4"-20 x 1/2" Socket cap head bolts

(1) 5/16"-18 x 1-1/4" Hex head bolt

(1) 5/16"-18 x 1" Hex head bolt

(1) 5/16"-18 x 3/8" Hex head bolt

(1) 5/16"-18 Nylock nuts

(2) Set screws

(1) Spacer

(2) Flat washers

(2) Nylon washers

(1) 5/16" Split lock washers

(1) Brass washer

(1) Spring washer

(2) #10-24 x 1/4" Slotted head bolts

(1) Carburetor assembly

(1) 17-1/2" Crankcase breather hose

(1) Chrome support bracket

(1) 12" Fuel line insulator hose

(2) Band clamps

(3) O-Rings

(1) 24" Clear overflow hose

(2) Stainless steel shims

(1) Throttle guide

(1) #10-24 x 1/2" Slotted head bolt

(1) Jet #066

(1) Jet #072

(1) Jet #070

(1) Jet #074

(1) Jet #076

(1) Jet #078

(1) Jet #068

(1) Jet #031

(1) Jet #028

(1) Jet #029.5

(1) Jet #026.5

(1) Flange

(1) Manifold insulator block

(1) Backplate gasket

(2) Small hose clamps

(2) 3/8"-16 x 1-1/4" Socket cap head bolts

Instructions

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.