Great idea but poor execution. I like to tie bags to the back seat and want to get rid of the grab bar which I installed to keep things from sliding back onto the fender. The item is powder coated stainless as advertised but the powder coating is the worst I've seen. I therefore stripped off the powder coating to leave it s/s or if the casting was a bad as it turned out to be I would just paint it. After stripping off the very thick powder coating I found the casting so bad it just wasn't worth the trouble to file, sand and polish. Threw it in the trash and going to make my own out of s/s or just make a new seat tie down a bit longer and slot it. Should also note that the powder coating is thick to cover up the poor casting. Also, one the powder coating is removed the part that fits over the seat mounting strap is too big and the part pivots slightly.