• Performance stepped headers with radial rear section
• Fabricated from 16-gauge double-wall steel
• Direct bolt-on design for easy installation
• 12mm O₂ sensor ports for fitment of stock sensors
• Slotted holes in heat shields
• Made in the U.S.A.

NOTE: Will not fit with passenger footpegs.

(1) Chrome steel front head pipe W/chrome steel heat shield installed

(1) Chrome steel rear head pipe W/chrome steel heat shield installed

(2) 5/16"-18 x 3/4" Hex head bolts

(2) 5/16" Flat washers

(2) 5/16" Split lock washers

(2) 18mm-12mm  02 Adaptors

(2) 12mm 02 Sensors

(1) Black steel mounting bracket

Instructions

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.