Woody’s® runners perfectly fit and guard the ski, while offering a cutting edge on hard-packed snow and ice. When tightened, Flat-Top® design offers increased surface area for less flexing and rocking with greater support and better steering than round top runners. All runners are made of durable steel with a combination of 60° carbide, hardweld and wear pads except Top-Stock® Hardweld Runners, which have no wear pad or carbide inserts.

Executive Series:

• 8 in. of 60 degree carbide with front and rear wear pads
• 1/2” round bar with Flat-Top® design
• Added balance for studded sleds

Trail Blazer IV Series:

• 6 in. of 60 degree carbide
• 1/2” round bar with Flat-Top® design
• Provides safety and control for both studded and un-studded sleds

Extender Trail III Series:

• 4 in. of 60 degree carbide
• 7/16” round bar with Flat-Top® design
• Entry-level carbide runner for lightly studded and un-studded sleds

Top Stock Hardweld Series:

• Steel round bar with Flat-Top® design
• Features strip of hardweld for added bar protection
• Not recommended for sleds with more than 48 studs

NOTE: Some models require drilling extra holes in skis to mount carbides. Dennis Kirk recommends removing any paint from the studs with a wire brush.

Dimensions:
Length: 14.02 in.
Stud Length x Diameter: (3) 1 3/4" x 5/16"-24
Number of Studs: 4
Stud Center Mounting Distance From:
Front to 1st: 1.81 in.
1st to 2nd: 3.05 in.
2nd to 3rd: 6.20 in.

(2) Wear rods

(6) Flange nylock nuts

Instructions