• Fuel control for each individual cylinder in a smaller enclosure
• Warm-up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
• Reduced size from the PCIII USB
• Easy to install
• USB powered from computer; 9 volt adapter is no longer needed
• Two-position map-switching function built in
• Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
• Gear/speed input allows for map adjustment based on gear
• Analog input allows user to install any 0-5 volt sensor
• Build an adjustment table based on analog input, such as boost or temperature
• With the gear position connected, Power Commander V is capable of allowing each cylinder to be mapped individually for each gear
• More tuning ranges than PCIII USB
• Enhanced accel pump utility
• Made in the U.S.A.

(1) Fuel injection module with wiring harness

(1) USB cable

(1) Alcohol pad

(2) Velcro strips

(3) Rubber port plugs

Instructions

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.