• Fuel control for each individual cylinder in a smaller enclosure
• "Warm-up" fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
• Reduced size from the PCIII USB
• Easy to install
• USB powered from computer; 9 volt adapter is no longer needed
• Two-position map-switching function built in
• Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
• Gear/speed input allows for map adjustment based on gear
• Analog input allows user to install any 0-5 volt sensor
• Build an adjustment table based on analog input such as boost or temperature
• Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
• More tuning ranges than PCIII USB
• Enhanced "accel pump" utility
• Made in the U.S.A.

NOTE: May not be legal for street use in CA.

(1) Power commander W/wiring harness

(1) 6' USB to mini USB cable

(2) Velcro® strips

(1) Alcohol pad

(1) Posi-tab

(3) Rubber port plugs

Instructions

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.