The new Power Commander V is loaded with tons of new features.

• Reduces size from PCIIIusb (less than half of the size of PCIII)
• USB powered from computer (9 volt adapter is no longer needed for programming)
• 2 position map switching function built in (map switch not included)
• Gear input (allows for map adjustment based on gear and speed)
• Analog input (allows used to install an 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature)
• With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables)
• Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes
• 10 throttle position columns (up from 9 on PCIIIusb)
• Enhanced accel pump utility (increased adjustment and sensitivity ranges)
  
  Included Items:
  (1) Fuel injection module with wire harness that includes (1) male ten pin connector, (1) female ten pin connector, (3) bare wires and (1) ring terminal
  (1) Secondary fuel module with wire harness that includes (1) male four pin connector, (1) female four pin connector and (1) ring terminal
  (1) 18 in. can link cable
  (2) 6' usb to mini usb cables
  (2) O2 optimizers
  (1) Can termination plug
  (3) Posi-taps
  (3) Black rubber plugs
  (4) 3/4 in. x 2 in. adhesive back velcro
  (1) Alcohol prep pad
  Instructions and a manual

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.