• Designed exclusively for Harley-Davidson Big Twin and Sportster engines
• Butterfly-type carbs with a fully adjustable idle mixture screw and a changeable mid-range and high speed jet
• Fully adjustable accelerator pump and a variable enrichment/fast idle device for improved throttle response, engine starting and warm-ups
• Super E has a 1 7/8" (47.6mm) throat at the butterfly and a 1 9/16" (39.6mm) venturi and is recommended for use on any displacement Big Twin or Sportster
• Super G has a 2 1/16" (52.3mm) throat at the butterfly and a 1 3/4" (44.5mm) venturi and is recommended for use on 74 cubic inch engines and larger where high performance modifications have been done or are planned (not recommended for smaller, lower compression engines)
• If you are not sure which carburetor to use, we suggest the 1 7/8" Super E
• Each complete carb kit includes: one S&S Super E or Super G gas carburetor, one S&S teardrop air cleaner assembly, one manifold, mounting hardware, fuel line, clamps, overflow line, one extra intermediate jet, two main jets, VOES tubing (when applicable), and installation and jetting instructions
  
  NOTE: Band Style Intake

(1) Chrome air cleaner cover

(1) Air cleaner

(1) Back plate

(1) Fast idle lever

(1) Elbow fitting

(1) Vent hose connector

(3) Support brackets

(1) 5/16"-18 x 1" Hex bolt

(1) 5/16"-18 Nylock nut

(3) 5/16" Flat washer

(2) Fast lever bolts

(1) Brass washer

(2) Nylon washers

(1) Friction washer

(1) 5/16" x 1/8" Flat washer

(1) 5/16" Lock washer

(1) 5/16"-18 x 1-1/4" Hex bolt

(1) 1/4"-20 x 3/4" Zinc plated oval head bolts

(1) 5/16"-18 x 5/8 Hex bolt

(2) 5/16" x .125 Shims

(3) 1/4"-20 x 1/2" Socket head bolts

(2) Back plate plugs

(1) Crank case breather hose

(1) Throttle cable guide

(2) 1 x .125 Shims 

(1) 3/8"-16 x 1-3/8" Socket head bolt

(1) Jet kit 110-0061

(2) TBC 238 Clamps

(2) Rubber guards

(1) Manifold insulator block

(1) Manifold gasket

(2) Clamps

(2) 3/8"-16 x 1-1/4" Socket cap bolt

(1) 24" Clear over flow hose

(1) 17-1/5" Fuel line

(1) 12" Fuel line insulator

(1) Carburetor assembly

Instructions 

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.