• Electric compression release for use with S&S cylinder heads and die cast rocker box covers for Big Twin with compression release machining
• Solenoid operated, this system automatically opens and closes when the starter button is pressed and released. Convenient and simple, this is the best setup for big displacement high compression bikes. 
• Kits include the required parts for installation
• For ease of installation and removal, a special socket can be purchased separately PART NO. 28-4229
• Not for use on OEM heads
• Made in the U.S.A.

NOTE:

If cylinder heads are machined for S&S compression releases, but compression releases are not used, special plug PART NO. 1400152 (two required) must be installed to seal the machined hole

SPECIAL FITMENT NOTE:

S&S® rocker covers are required if S&S cylinder heads are used with S&S electric compression releases

SPECIAL FITMENT NOTE:
WILL NOT REPLACE STOCK OEM HARLEY COMPRESION RELEASES

(2) Compression releases W/(2) Wires with male bullet connectors

(2) Plastic wire connectors

(2) Rubber caps

(2) 16" Long wire coverings

(2) Wiring harnesses each W/(1) 2-pin connector and (1) Wire

(1) 15 Amp in-line fuse assembly

(2) 2" Long shrink tubing 

(1) 48" Long wire covering

(2) Ring terminals

(2) Female bullet connectors

(2) Female spade terminals

Instructions