• This Sterling Chromite II Designer Handlebar Installation Kit is for 10" - 12" Ape hanger handlebars.
• The kit will include a hydraulic clutch line, non-ABS brake lines, copper crush washers, hardware, and wiring extensions.
• All fittings are highly polished and chrome plated.
• Kits for dual disc models include an all brazed manifold that eliminates leaks, alignment problems, and unattractive threaded connections.
• Brake lines exceed all DOT FMVSS-106 requirements.
• Made in the USA

Note: Kits are based on using ape hanger style handlebars with 2" risers.

(1) Sterling chromite II clutch cable, measures 64-1/2" housing and 2-3/4" travel

(2) Cable ties

(1) Plastic barrel

(1) O-ring

(1) Sterling chromite II throttle cable, measures 36-1/4" housing, 4-3/4" 50-degree elbow, and 5" travel

(1) Sterling chromite II idle cable, measures 36-1/4" housing, 4-3/4" 50-degree elbow, and 4-5/8" travel

(2) Brass barrels

(1) 28-1/2" Sterling chromite II brake line W/(1) female AN#3 fitting and (1) 3/8"/10mm straight banjo fitting

(1) 14-7/8" Sterling chromite II brake line W/(1) 3/8"/10mm 60-degree banjo fitting and (1) chrome junction block W/(1) male AN#3 fitting

(4) 3/8"/10mm Copper crush washers

(1) Turn signal extension kit including (6) 14-1/2" Wires W/bullet connectors, (2) 14" Shrink tubing, and (6) 2-1/2" Shrink tubing

(2) 16-1/2" Can-bus wiring harnesses

Instructions