Overview of Klock Werks Super Saver 4 in. Back Slash Slip-On Mufflers - 18010351
- Feature rolled-edge ends in three different designs
- Steel construction with a flawless chrome finish
- Feature 2 in. spiral-louvered fiberglass-wrapped removable and repackable baffles
- Throaty rumble at idle and under acceleration; decreases to a low hum under steady cruising
- Standard length: 30"
- Sold in pairs
- Made in the U.S.A.
(2) Muffler Bodies
(4) 5/16 x 18 x 3/4 in. Carriage Bolts
(4) 5/16 x 18 Lock Nuts
(4) 3/8 i.d. x 1/8 long x 3/4 o.d. Spacers
NOTES: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see FUEL/INTAKE section.
There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See CHEMS/LUBES section for products that will help prevent or remove bluing
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for Klock Werks Super Saver 4 in. Back Slash Slip-On Mufflers - 18010351
Alternate/OEM Part Number(s):