• Features fuel and timing control, Rev Xtend and is a reduced size from the PCIII USB
• Warm-up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
• The Power Commander III USB allowed you to add extra fuel during start-up based on number of revolutions of the engine
• Now the easy-to-install Power Commander V reads the exact engine temp through the bikes own ECM, allowing the tuner to choose how much fuel to add
• More tuning ranges than PCIII USB
• Enhanced accel pump utility
• USB powered from computer; 9 volt adapter is no longer needed
• Cold starting on heavily modified engines should now be much more controllable and easy to adjust
• Software displays J1850 data from bikes stock ECU
• Two-position map switching function built in
• Can add any SPST switch and toggle between two different fuel/timing maps
• Gear/speed input allows for map adjustment based on gear
• Analog input allows user to install any 0-5 volt sensor
• Build an adjustment table based on analog input such as boost or temperature
• Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
• Ten throttle position columns
• Made in the U.S.A.
  
  Included Items:
  (1) Fuel injection module with wire harness that includes (2) male eighteen pin connectors and (2) female eighteen pin connectors
  (2) O2 optimizers
  (1) 6 in. USB to mini USB cable
  (3) Black rubber plugs
  (2) 1 in. x 2 in. adhesive back velcro
  (1) Alcohol prep pad
  Instructions and a manual

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.