Fuel control for each individual cylinder in a smaller enclosure
•Warm-up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
•Reduced size from the PCIII USB
•Easy to install
•USB powered from computer; 9 volt adapter is no longer needed
•Two-position map-switching function built in
•Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
•Gear/speed input allows for map adjustment based on gear
•Analog input allows user to install any 0-5 volt sensor
•Build an adjustment table based on analog input such as boost or temperature
•Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
•More tuning ranges than PCIII USB
•Enhanced "accel pump" utility
•Made in the U.S.A.

SECONDARY FUEL MODULE
•Allows for the adjustment of all eight-injectors
•Connects to the upper injector rail using OEM connectors
•Single cable connection to the PCV
•Adjust both upper and lower injectors by as much as +250/-100%
•If gear position input is connected to your PCV, you can adjust all of the injectors on a "per gear" basis
•You can also map each injector separately; giving you up to 48 complete maps
•The "basic" mode allows you to have a single fuel table that simply puts the requested fuel change in both upper and lower injector modules at the same time
•The "basic" mode is the perfect setting for modified engines that require more fuel than four-injectors can provide, but do not need the complexity of mapping each cylinder and each gear separately

FITMENT: 
MV AGUSTA - F4 1000 - 2014

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.