The New Power Commander V is loaded with tons of new features. Below you will find some Power Commander V features.

• Reduced size from PCIIIusb (less than half of the size of PCIII)
• USB powered from computer (9 volt adapter is no longer needed for programming) 
• 2 position map switching function built in (map switch not included) 
• Gear input (allows for map adjustment based on gear and speed)
• Analog input (allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature) 
• With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables). 
• Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes 
• 10 throttle position columns (up from 9 on PCIIIusb) 
• Enhanced “accel pump” utility (increased adjustment and sensitivity ranges)

(1) Fuel injection module with wiring harness

(1) 6' USB cable to mini USB

(2) Velcro® strips

(3) Rubber port plugs

(2) O2 optimizer

(1) Alcohol swab

Instructions

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.