• Reduces size from PCIIIusb (less than half of the size of PCIII)
• USB powered from computer (9 volt adapter is no longer needed for programming)
• 2 position map switching function built in (map switch not included)
• Gear input (allows for map adjustment based on gear and speed)
• Analog input (allows used to install an 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature)
• With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables)
• Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes
• 10 throttle position columns (up from 9 on PCIIIusb)
• Enhanced accel pump utility (increased adjustment and sensitivity ranges)
  
  Included Items:
  (1) Fuel injection module with wire harness which includes (1) ring terminal, (4) male two spade connector, (1) female two spade connector, (1) male three pin connector and (1) female three pin connector
  (1) 6 foot usb cable
  (1) 2 in. x 5/8 in. adhesive back velcro tapes
  (3) Black rubber plugs
  (1) Alcohol prep packet
  (1) CD-rom
  Instructions and a manual
  (1) O2 optimizer with four male spade connector

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.