• Features fuel and timing control, Rev Xtend and is a reduced size from the PCIII USB
• "Warm-up" fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
• The Power Commander III USB allowed you to add extra fuel during start-up based on "number of revolutions" of the engine - Now the easy-to-install Power Commander V reads the exact engine temp through the bike's own ECM, allowing the tuner to choose how much fuel to add
• More tuning ranges than PCIII USB
• Enhanced "accel pump" utility
• USB powered from computer; 9 volt adapter is no longer needed
• Cold starting on heavily modified engines should now be much more controllable and easy to adjust
• Software displays J1850 data from bikes' stock ECU
• Two-position map switching function built in
• Can add any Single Pole Single Throw switch and toggle between two different fuel/timing maps
• Gear/speed input allows for map adjustment based on gear
• Analog input allows user to install any 0-5 volt sensor
• Build an adjustment table based on analog input such as boost or temperature
• Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
• Ten throttle position columns
• Made in the U.S.A.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.