• Fuel control for each individual cylinder in a smaller enclosure
• "Warm up" fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
• Reduced size from the PCIII USB
• Easy to install
• USB powered from computer; 9 v/li>
• Two-position map switching function built-in
• Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
• Gear/speed input allows for map adjustment based on gear
• Analog input allows user to install any 0-5 volt sensor
• Build an adjustment table based on analog input such as boost or temperature
• Power Commander V is capable of allowing each cylinder to be mapped individually and 10 throttle position columns for each gear with the gear position input connected
• Unit has a -100/+250% fuel change range, this allows more adjustment range for 8 injector sportbikes
• More tuning ranges than PCIII USB
• Enhanced "accel pump" utility
• Made in the U.S.A.
  
  Included Items:
  (1) Power commander fuel injection module with wire harness
  (1) USB cable 6 foot
  (1) CD-Rom
  (3) Port plugs
  (2) Velcro strips
  (1) Alcohol prep pad

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.