• Maintains clean, pure traditional drag-pipe look
• Full-length, 2.5 in. heat shields
• 222 degrees wraparound for a non-bluing appearance
• Beautifully machined and chromed billet tips
• Removable baffles
• Easy to install
• Made in the U.S.A.

For replacement baffle use 44-02773

NOTE: System includes oxygen sensor bungs installed

Included Items:
(1) Front Exhaust Assembly w/Heatshield
(1) Rear Exhaust Assembly w/Heatshield
(1) Exhaust Bracket
(1) Regulator Bracket
(4) Clamps (HS-24)
(2) Clamps (HS-28)
(2) Billet Exhaust Tips
(1) Bolt, Hex (3/8 x 1.00)
(4) Bolt, Hex (5/16-18 x 5/8)
(2) Screw, Button (1/4-20 x 3/8)
(1) M10 x 20mm Bolt
(1) M10 Flat Washer

Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.

Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section

Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.