• Grab some attention with these deep rumbling pipes
• For increased low and mid-range power the Cobra PowerPort is included
• 1-3/4 in. head pipes, full-length 2-3/4 in. heat shields to give the pipes the correct look are included
• Heat shields will not discolor
• Removable power cores
• Made in the U.S.A.

Included Items:
(1) Front headpipe w/heatshield
(1) Rear headpipe muffler w/heatshield
(1) Exhaust bracket
(1) Regulator bracket
(5) Hose clamps HS-24
(2) Hose clamps HS-28
(1) Clamp, 27-61 MSC
(3) Bolt, Hex 5/16-18 x 5/8
(2) Bolt, Hex 6mm x 20mm
(1) Bolt, M10-1.25 x 80mm
(1) Bolt, M10-1.25 x 60mm
(1) Nut, M10-1.25 Nylock

NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturers information.

Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the Intake/Fuel section.

Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.