|For models listed w/Forward or Mid Controls
NOTE: 12-up models require O2 sensor port 18mm to 12mm adaptors - Part No. 44-06482
(1) Front Headpipe/Heat shield
(1) Rear Headpipe/Heat shield
(1) Front Headpipe w/muffler and baffle
(1) Rear Headpipe w/muffler and baffle
(5) #24 Hose clamps
(4) 5/16-18 x 3/4 in. Square head bolts
(4) 5/16-18 Serrated flange nuts
(1) Mounting bracket
(1) 5/16-18 x 1-3/4 in. Hex head bolt
(1) 5/16 in Flat washer.
Note: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
Note: Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the manufacturer directly with questions regarding any modifications that may need to be made during, or after installing their product. If a jet kit or EFI controller is recommended please see the Intake/Fuel section for products available
Note: There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (blueing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See the CHEM/LUBES category for products that will help prevent or remove blueing.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
|Color - Primary||Black|
Part 4404789 fits the following machines