Accutronix has added LED turn signals to our line of products. These LED turn signals fit nicely between the saddlebag & fender on a custom FLH or on any flat surface. They are a great solution for adding rear lights to custom baggers. The LED unit is a 3-wire light & can be used as a running, turn and/or brake light (RED only). You may need a load equalizer or turn signal controller depending on your application. Our billet housing is 7-3/8 in. Long & 1-1/2 in. Wide. The LED unit has 10 LED's & is 5-1/4 in. Long & 1/2 in. Wide. Approximately 3/4 in. of clearance is needed behind the surface you cut these lights into. Machined from 6061 T-6 Billet aluminum and brilliantly Black Anodized finish.

• Sold in pairs
• Proudly made in Phoenix Arizona, USA

(2) LED Lights W/ Amber Lens and Wiring Harness (Red, White, Black)

(2) Black Aluminum Plates

(4) 1/4"-20 X 5/8" Studs W/ Nylock Nut

(4) 1/4" Flat Washers

Instructions