• Fuel control for each individual cylinder in a smaller enclosure
• Warm up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
• Reduced size from the PCIII USB
• Easy to install
• USB powered from computer; 9 volt adapter is no longer needed
• Two-position map switching function built-in
• Can add any Single Pole Single Throw (SPST) switch and toggle between two different fuel maps
• Gear/speed input allows for map adjustment based on gear
• Analog input allows user to install any 0-5 volt sensor
• Build an adjustment table based on analog input such as boost or temperature
• Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
• More tuning ranges than PCIII USB
• Enhanced accel pump utility
• Made in the U.S.A.
  
  Included Items:
  (1) Power commander with (1) male three spade connector, (1) female three spade connector, (1) female nineteen pin connector and (1) male nineteen pin connector with aluminum lock ring
  (1) 72 in. USB cable
  (3) Rubber plugs
  (1) Alcohol prep packet
  (2) 2 in. x 5/8 in. self adhesive velcro strip
  (1) CD-rom

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.