• Reduced size from PCIIIusb (less than half of the size of PCIII)
• USB powered from computer (9 volt adapter is no longer needed for programming)
• 2 position map switching function
• Gear input (allows for map adjustment based on gear and speed)
• Analog input (allows user to install any 0-5 volt sensor and build an adjustment table based on its input such as boost or temperature)
• With gear position input connected the PCV is capable of allowing each cylinder to be mapped individually and for each gear (for example: on a 4 cylinder bike with a six speed transmission there could be up to 24 separate fuel tables).
• Unit has a -100/+250% fuel change range (up from -100/+100%). This allows more adjustment range for 8 injector sportbikes
• 10 throttle position columns (up from 9 on PCIII USB)
• Enhanced accel pump utility (increased adjustment and sensitivity ranges)
  
  Included Items:
  (1) Power Commander V with wire harness included (3) male two pin connectors
  (3) Female two pin connectors and (1) ring terminal
  (1) 6' usb to mini usb cord
  (2) 5/8 in. x 2 in. adhesive back velcro strips
  (1) Alcohol prep pad
  (1) CD-Rom
  (3) Black rubber plugs
  (2) O2 optimizer
  Instructions and a manual

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.