NOTE: Pre 07 models will require O2 sensor port kit - pn 44-03276
(1) Front header assembly
(1) Rear header assembly
(1) Front heat shield
(1) Rear heat shield
(1) Mounting bracket
(1) Nylon cable tie
(2) Dogbone nut plates
(1) 3/8 x 2-1/2 in. Allen bolt
(2) 3/8 x 3/4 in. Flange head bolts
(4) 5/16 x 5/8 in. Flange head bolts
(4) #20 Hose clamps
(2) #28 Hose clamps
NOTE: Will not accept Hot Tips
NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturer's information.
There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc, and is not caused by defective manufacturing. See lubrication products to help prevent or remove bluing
For the best performance, a free-flowing air cleaner and carb re-jet kit or adjustable fuel management system is recommended with this pipe.
Recommended Vance & Hines fuel management module: Fuel Pak FP3 (part number 2001886) For CAN Bus models only (Touring, Softail, Dyna and Sportster). Not compatible with V-Rod models
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Part 4404943 fits the following machines