Overview of Vance & Hines CS One Dual Slip-On Mufflers - 45505
End Cap: Aluminum
(1) Yam R1 09 RH mid pipe
(1) Yam R1 09 LH Mid pipe
(1) 09 R1 RH heat shield
(1) 09 R1 LH Heat shield
(1) BLK CS1 SS RD 12" muffler casing
(1) BLK CS1 SS LH 12" Muffler casing
(1) Band clamp:CS1:SS RH undertail
(1) Strap:Rubber: CS1
(1) Band Clamp:CS1:SS LF undertail
(1) Tie bar bracket under tail
(4) R1 aluminum spacer cap washer
(2) 1.81"-1.99" barrel band clamp
(1) Spring puller tool
(2) M8 x 1.25 x 12mm socket head, button head
(4) Exhaust spring 53 MM
(4) Bolt, button head M5x6mm
NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
NOTE: There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (blueing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See the CHEMS/LUBES section in the back of this catalog for products that will help prevent or remove blueing.
NOTE: Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during. or after, installing their product. If a jet kit or fuel processor is recommended, see the FUEL/INTAKE section
Cross reference number(s):18112242
Specs for Vance & Hines CS One Dual Slip-On Mufflers - 45505
Fitment for Vance & Hines CS One Dual Slip-On Mufflers - 45505See if this part fits your ride
Part 4405224 fits the following machines
- 2014 Yamaha YZF-R1 1000
- 2013 Yamaha YZF-R1 1000
- 2012 Yamaha YZF-R1 1000
- 2011 Yamaha YZF-R1 1000
- 2010 Yamaha YZF-R1 1000
- 2009 Yamaha YZF-R1 1000
- 2010 Yamaha YZF-R1 LE 1000 Limited Edition
Received my slip ons the other day. Well packed, but after opening I noticed the cans had a lot of little nicks and scuffs on them.
One can had a small dent and scratch on the top. Someone tried covering it up with what looks like black sharpie. Whatever they used doesnt match the paint and is shiny when light hits it. Way to phone it in.
Flange where it attaches to exhaust was flattened on one side like it got dropped, I had to flare it back out to install.
Bolt to attach can to bracket had mangled threads making it impossible to put the nut on.
And last, the cans dont line up when looking at the bike from the rear. One side sticks out significantly further than the other.
I wont comment on the sound since its so subjective. But the build quality is poor. Too bad since I was really looking forward to these.
On the plus side they look nice from the side and were a breeze to install.