Overview of Vance & Hines Cruzers Exhaust System - 31467
|Designed and manufactured in the U.S.A., Vance & Hines systems lead the industry in high-performance technology
(1) Front Head Pipe
(1) Rear Head Pipe
(1) Front Heat Shield
(1) Rear Heat Shield
(1) Mounting Bracket
(2) 10mm Washers
(7) #20 Hose Clamps
(2) 10mm x 40mm Flange Bolts
(2) 10mm Locknuts
(4) 5/16 in. x 5/8 in. Flange Bolts
(2) 6mm Washers
(2) 6mm x 30mm Flange Bolts
(2) 6mm Locknuts
Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.
Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Cross reference number(s):18100555
Specs for Vance & Hines Cruzers Exhaust System - 31467
|Color - Primary||Chrome|
Fitment for Vance & Hines Cruzers Exhaust System - 31467See if this part fits your ride
Part 4400281 fits the following machines
- 2009 Honda VTX1300C
- 2008 Honda VTX1300C
- 2007 Honda VTX1300C
- 2006 Honda VTX1300C
- 2005 Honda VTX1300C
- 2004 Honda VTX1300C
- 2009 Honda VTX1300R
- 2008 Honda VTX1300R
- 2007 Honda VTX1300R
- 2006 Honda VTX1300R
- 2005 Honda VTX1300R
- 2007 Honda VTX1300S
- 2006 Honda VTX1300S
- 2005 Honda VTX1300S
- 2004 Honda VTX1300S
- 2003 Honda VTX1300S
SIncerely Jack D.
Look great, sound awsome, and a breeze to install...20 minutes to install. that is with my old system off and waiting for the UPS guy at the door...
Installed on a 2009 SUZUKI M50 Boulavard. VZ800 limited.
No injector mods needed, i probably got 3-5 HP more..and they run COOLER than the stock..no more SIZZLE on the ladies legs.. Dont even think about other pipes..these are increadible for the $$...just dont take out the baffles...lol
And Dennis Kirk was very helpful and curtious as usual ;)
I emailed Vance & Hines regarding the fit and it's been about a week with no progress with their technical department.