Need Assistance?
Legendary Service... Ask Your Friends - Since 1969
800.969.7501
Over 160K Powersport Items - In-Stock and ready to ship today! View tires, apparel, helmets, exhaust and more!

Vance & Hines Cruzers Exhaust System - 31403

  • Part #:
    445201
  • Manufacturer Part #:
    31403
This item is no longer available

Overview of Vance & Hines Cruzers Exhaust System - 31403

Designed and manufactured in the U.S.A., Vance & Hines systems lead the industry in high-performance technology
  • Same great features as the Classics II line but at a more affordable price
  • All are 3 in. diameter slash-cut end style with chrome plated, custom 220º plasma-arc cut full-length heat shields to hide any possible bluing
  • Removable, re-packable baffles wrapped in fiberglass
  • Come complete with all necessary mounting hardware and instructions
  • Carburetor re-jetting or a Vance & Hines Power Commander may be necessary for optimum performance

Included Items:
(1) 2/2 Exhaust system
(1) Front Heat Shield
(1) Rear Heat Shield
(1) Rear bracket
(2) Dogbone nut plates
(2) 9/16 x 1-1/16 in. Grommets
(3) 8.4mm x 30mm Washers
(1) 8mm-1.25 x 25mm Sockethead cap screws
(5) 1/75 in. Clamps
(4) 5/16-18 x 5/8 in. Flange bolts
(3) Tube spacers
(1) Instructions

Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.

Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section

Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.

Specs for Vance & Hines Cruzers Exhaust System - 31403

Color - Primary Chrome
Finish Chrome
Style Bologna/Slash-Cut Tip
Type 2-Into-2 System
Units Each
Weight 20.25 lbs

Cross reference number(s):

V31403

Specs for Vance & Hines Cruzers Exhaust System - 31403

Color - Primary Chrome
Finish Chrome
Style Bologna/Slash-Cut Tip
Type 2-Into-2 System
Units Each
Weight 20.25 lbs

Fitment for Vance & Hines Cruzers Exhaust System - 31403

See if this part fits your ride

Part 445201 fits the following machines

Honda
  • 2007 Honda VT600C Shadow VLX
  • 2006 Honda VT600C Shadow VLX
  • 2005 Honda VT600C Shadow VLX
  • 2004 Honda VT600C Shadow VLX
  • 2003 Honda VT600C Shadow VLX
  • 2002 Honda VT600C Shadow VLX
  • 2001 Honda VT600C Shadow VLX
  • 2000 Honda VT600C Shadow VLX
  • 1999 Honda VT600C Shadow VLX
  • 1997 Honda VT600C Shadow VLX
  • 1996 Honda VT600C Shadow VLX
  • 1995 Honda VT600C Shadow VLX
  • 1994 Honda VT600C Shadow VLX
  • 1993 Honda VT600C Shadow VLX
  • 1992 Honda VT600C Shadow VLX
  • 1991 Honda VT600C Shadow VLX
  • 1989 Honda VT600C Shadow VLX
  • 1988 Honda VT600C Shadow VLX
  • 2007 Honda VT600CD Shadow VLX Deluxe
  • 2006 Honda VT600CD Shadow VLX Deluxe
  • 2005 Honda VT600CD Shadow VLX Deluxe
  • 2004 Honda VT600CD Shadow VLX Deluxe
  • 2003 Honda VT600CD Shadow VLX Deluxe
  • 2002 Honda VT600CD Shadow VLX Deluxe
  • 2001 Honda VT600CD Shadow VLX Deluxe
  • 2000 Honda VT600CD Shadow VLX Deluxe
  • 1999 Honda VT600CD Shadow VLX Deluxe
  • 1998 Honda VT600CD Shadow VLX Deluxe
  • 1997 Honda VT600CD Shadow VLX Deluxe
  • 1996 Honda VT600CD Shadow VLX Deluxe
  • 1995 Honda VT600CD Shadow VLX Deluxe
  • 1994 Honda VT600CD Shadow VLX Deluxe
  • 1993 Honda VT600CD Shadow VLX Deluxe
  • 2000 Honda VT600CD2 Shadow VLX
  • 1999 Honda VT600CD2 Shadow VLX
4.9 / 5.0
98 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
91
6
1
0
0
Finish
4.9 / 5
Performance
4.9 / 5
Loudness
Very Quiet
Average
Very Loud
Finish
5 / 5
Loudness
Very Quiet
Average
Very Loud
Performance
5 / 5
Just the sound I wanted!
Great set of pipes. Went on easy. Sound great. Look great. Gets rid of the heavy/restrictive stock system. Very nice improvement.
October 5, 2009
Finish
5 / 5
Loudness
Very Quiet
Average
Very Loud
Performance
5 / 5
WOW: Best Purchase next to my bike
I have been riding for a long time started around 1968 and enjoyed the freedom the bike give you. but always stuck with stock exhaust. My son ride a Harley 1400 CC modified. runs drag pipes it's loud to say the least. I wanted to change the sound of my 750 Vulcan with out spending a fortune. This system was right in the price range I was looking for with out rejeting my carb's. Runs great after instalation sound great and love the look. Took me about 2 Hr's from start to crank up, no special tools needed not to mention loosing that box that runs between the frame of the factory system, picked up some power and a couple of miles to the gallon. had a lot of complements at idle that deep romble sounds good. and when you take off it sound like a much biger bike than it is. OH Im going to be 69 in July. and I do live to ride. I Ride with a younger crowd and keep up with or out front of. This is a good buy and yes I would reccomend Dennis Kirk and Vance & Hines. Oh when I finished there were NPLO.( No Parts Left Over) and the fitting was perfict.
SIncerely Jack D.
March 31, 2010
Finish
5 / 5
Performance
5 / 5
Make Your VTX Come Alive
Unbelievable!! Don't even think about it..Just get these pipes. They went on so easily. It took me about an hour and a half to remove the old system and install these. The was a very noticeable weight difference too as I am guessing the V&H weighed about 50 pounds less. Everything fit perfect and instructions were easy to follow. The product arrived ahead of time and all parts were in the box which was packaged very well and undamaged. The sound is awesome. It doesn't sound like a HD want to be….It sounds deep and strong from idle to ripping down the road. And while crazing….It purrs like a mountain lion. I am totally happy with the look and sound. I also installed a K&N filter and did not re-jet my carb. With this setup it got rid of the cold blooded warm ups. I am 110% HAPPY with this purchase and Dennis Kirk beat everyone else's price hands down.
May 11, 2010
Finish
5 / 5
Performance
5 / 5
Great product good price
I questioned the quality of these pipes because they are priced much cheaper than many others. I was suprised to find a very nice chrome finnish with the vance&hines logo eteched into the full lengh heat shields. Instal was a breeze with easy to understand instructions. A bit louder than I had expected but not overbearing. I cant wait for spring so I can get out on the road and see what they sound like with some speed.
February 7, 2010
Finish
5 / 5
Performance
5 / 5
THESE PIPES BLOW!!
BLOW OTHERS OUT OF THE WATER THAT IS !! LOL
Look great, sound awsome, and a breeze to install...20 minutes to install. that is with my old system off and waiting for the UPS guy at the door...
Installed on a 2009 SUZUKI M50 Boulavard. VZ800 limited.
No injector mods needed, i probably got 3-5 HP more..and they run COOLER than the stock..no more SIZZLE on the ladies legs.. Dont even think about other pipes..these are increadible for the $$...just dont take out the baffles...lol
And Dennis Kirk was very helpful and curtious as usual ;)
August 16, 2010
Finish
5 / 5
Performance
5 / 5
Great Pipes
Delivered within 3 days. Easy to install. Great sound and look excellent. Installed them on a Kawasaki Vulcan VN750A. Bike starts easier and didn't have to re-jet. Noticible increase in performance.
May 14, 2010
Finish
5 / 5
Performance
5 / 5
The guys are envious of these pipes !!!
Just get these pipes...they are THE BEST purchase I have made to date. Installation on my 2009 Honda Shadow C2 was a snap, took about 1 hour. The sound is mellow and throaty, will turn heads to say the least. I had a little trouble touching the ground with the stock pipes (4'11" female) but now I have no problem flat footing. Not too loud for extendend rides, quiet on take off, but will RIP IT UP when you're ready to !!!! No rejetting done.
June 11, 2010
Finish
5 / 5
Performance
5 / 5
Quality product
Very nice product, good instructions, all the parts and pieces were in the bag. The fit and finish is very nice. They are a little louder than I was expecting but they have a very nice sound & I will get used to it. It is a large safety help as "Loud Pipes Save Lives".
June 15, 2011
Finish
5 / 5
Performance
4 / 5
Exactly what I was hoping for
The stock pipes on my 2005 Vulcan 800 Classic were cracked with pieces of the baffles rattling around inside the pipe. I researched which replacement pipes would sound the best on my bike and picked the V&H Cruzers. I installed them myself with very little trouble, and when I turned the key and hit the switch I couldn't stop smiling. GREAT sound! Look great. Now I just need to get a jet kit installed, because the pipes do seem to backfire quite a bit now. I would definitely recommend these pipes to other Vulcan riders out there. It will make your small metric sound like the "real deal."
August 11, 2011
Finish
4 / 5
Performance
5 / 5
What a difference
Bike sounds so much better. They are deeper and louder at idle. But when you get on that throttle boy do they bark. Performance has improved also. Much more pep at takeoff and more throttle left when on the highway. Do not hesitate and buy these pipes now.
June 24, 2010
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Instructions and Manuals for Vance & Hines Cruzers Exhaust System - 31403

You May Also Be Interested In