(1) Mounting bracket
(1) Muffler body
(1) Front heat shield
(1) Rear heat shield
(1) Collector heat shield
(1) Muffler body heat shield
(2) Nylon cable ties
(1) #56 Hose clamp
(1) #44 Hose clamp
(6) #24 Hose clamps
(3) #20 Hose clamps
(1) Torca band clamp
(1) Dogbone nut plate
(2) 5/16-18 x 5/8 in. Flange bolts
(1) 3/8-16 x 1-1/2 in. Allenhead bolt
(1) 3/8-16 x 3 in. Allenhead bolt
(2) 3/8 in. Lock washers
(3) 3/16 x 1 in. Flat washers
NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
There is no warranty on exhaust pipes and mufflers with regard to any discoloration. Discoloration (bluing) is the result of tuning characteristics, cam timing, carburetor jetting, overheating, etc., and is not caused by defective manufacturing. See the CHEMS/LUBES section in the back of this catalog for products that will help prevent or remove bluing.
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during. or after, installing their product. If a jet kit or fuel processor is recommended, see the FUEL/INTAKE section.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
|Color - Primary||Chrome|
Part 4404945 fits the following machines