Legendary Service... Ask Your Friends - Since 1969
Need Assistance?
Over 150K Powersport Items - In-Stock and ready to ship today! View tires, apparel, helmets, exhaust and more!

Vance & Hines Big Shots - 18287

  • Part #: 4402280
  • Manufacturer Part #: 18287
Our Price: $749.99
3 on Hand

Overview of Vance & Hines Big Shots - 18287

  • Dramatically increases horsepower and torque
  • Supplied with the Vance &Hines Power Chamber, a unique crossover system that offers all the performance advantages of a two-into-one race system
  • Mammoth 2.5 in. full coverage heat shields
  • Removable baffles and racy billet end tips
  • Virtually blue-proof
  • For maximum performance a Vance &Hines Power Commander is recommended


Included Items:
(1) - Suz M109R 2-2 Header
(1) - Rear Heat Shield
(1) - Front Cylinder Muff Heat Shield
(1) - Powder Coated Rear Bracket
(10) - 1.75" SS Clamp for HD
(4) - 5/16-18 x 5/8 Serrated Flange Bolt
(2) - 6mm x 1.0 x 55mm Hex Flange (8.8)
(4) - 6.4mm x 18mm x 1.6mm Washer
(1) - 5.3mm x 15mm x 1.2mm Washer
(1) - 18287 Instruction Rev 1.0
(1) - Front Heat Shield
(1) - Front hs Rear Section
(1) - Rear Cylinder Muff Heat Shield
(1) - M109R Servo Adaptor Cam
(2) - Gof Bone Nut Plate
(4) - 3.00" SS Clamp for V-rod
(2) - M6-1.0 Nylock Hex Nut
(2) - .25" x .37" x 1.0" Spacer
(4) - M8-1.25 x 35MM SHCS Zinc

Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.

Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section

Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.

Specs for Vance & Hines Big Shots - 18287

Color - Primary Chrome
Finish Chrome
Style Bologna/Slash-Cut Tip
Type 2-Into-2 System
Units Each
Weight 46.20 lbs

Specs for Vance & Hines Big Shots - 18287

Color - Primary Chrome
Finish Chrome
Style Bologna/Slash-Cut Tip
Type 2-Into-2 System
Units Each
Weight 46.20 lbs

Fitment for Vance & Hines Big Shots - 18287

See if this part fits your ride

Part 4402280 fits the following machines

Suzuki
  • 2014 Suzuki VZR1800 Boulevard M109R
  • 2013 Suzuki VZR1800 Boulevard M109R
  • 2012 Suzuki VZR1800 Boulevard M109R
  • 2011 Suzuki VZR1800 Boulevard M109R
  • 2009 Suzuki VZR1800 Boulevard M109R
  • 2008 Suzuki VZR1800 Boulevard M109R
  • 2007 Suzuki VZR1800 Boulevard M109R
  • 2006 Suzuki VZR1800 Boulevard M109R
  • 2009 Suzuki VZR1800N Boulevard M109R2
  • 2008 Suzuki VZR1800N Boulevard M109R2
  • 2016 Suzuki VZR1800N Boulevard M109RB B.O.S.S.
  • 2015 Suzuki VZR1800N Boulevard M109RB B.O.S.S.
  • 2014 Suzuki VZR1800N Boulevard M109RB B.O.S.S.
  • 2014 Suzuki VZR1800Z Boulevard M109RZ Limited
  • 2013 Suzuki VZR1800Z Boulevard M109RZ Limited
  • 2012 Suzuki VZR1800Z Boulevard M109RZ Limited
  • 2011 Suzuki VZR1800Z Boulevard M109RZ Limited
  • 2009 Suzuki VZR1800Z Boulevard M109RZ Limited
  • 2008 Suzuki VZR1800Z Boulevard M109RZ Limited
  • 2007 Suzuki VZR1800Z Boulevard M109RZ Limited
4.6 / 5.0
24 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Star
17
6
0
0
1
Finish
4.9 / 5
Performance
4.8 / 5
Finish
4 / 5
Performance
3 / 5
Never Again
I got these pipes for my bike. 12 month(25,000 miles) later, one of the clamps holding the heat shield gave out. Replaced it with a heavier clamp. 1 month later heat shield started rattling again. This time one of the brackets on the heat shield had broken loose. Too the shield off and found that another bracket had broken also. Looking closer I found that every weld on the pipes themselves had failed as well. Called V&H and was told they are out of warranty. Another company has a good set of pipes with a lifetime warranty. 45,000 miles later, they still look and sound like new. V&H? Never again.
September 26, 2009
Finish
5 / 5
Performance
5 / 5
Practice Patience
The look, sound and performance of this exhaust are among the most pleasing on the market. The fitment leaves a lot to be desired. They don't line up withe headers so protect that chrome and grab your pry bar! The plate that mounts the rear of the pipes have mounting holes for the rectifier that need to moved to the right about 1/4 inch so you don't have to re route the wires. Vance Hines should take note these issues as I'm sure it will cost them sales. I can fabricate so I dealt with it although I agree you shouldn't have to. I removed the baffles and cut the fiberglass batting and the end cap off and reinstalled them. I wanted louder. There was no need for fuel management on my VTX 1800 all though they would love to sell it. You may see and hear the finished product by visiting this URL http://www.youtube.com/watch?v=nB_nnSJPhRQ
August 2, 2010
Finish
4 / 5
Performance
4 / 5
Vance and Hines Big Shots
These are really nice looking pipes that sound great! You will need some help installing them. They could do a better job bending the pipes to fit.
May 16, 2011
Finish
4 / 5
Performance
5 / 5
Big Shots
I purchased these after seeing and hearing them on other V-Star 1300's. They were incredibly easy to install, they look and sound great and they are reasonably priced.
October 14, 2009
Finish
5 / 5
Performance
5 / 5
No Review Title Entered By User
One of the best investments that I made for my VTX 1300C. Love the way it looks and sounds. Thanks to Dennis Kirk for fast shipping and good prices.
January 1, 2013
Finish
5 / 5
Performance
5 / 5
Vance&Hines
My vance and hines were installed on a 07 vtx 1300c. You need a little muscle to install but not to hard. I think vance and hines should make a better looking clamp or a chrome cap to cover screw heads. Other than that i'm very pleased. Dennis kirk has fast shipping, and if your like me you want your toy fixed fast.
December 14, 2010
Finish
5 / 5
Performance
5 / 5
Best Pipes I've Had
These pipes are amazing! Was an easy install. Looks and Sounds amazing.
May 31, 2012
Finish
5 / 5
Performance
5 / 5
definitely better than stock
...but not quite as deep a sound as i was hoping for. Like the pipes, install was super easy and they are certainly loud. Installed on an '05 honda vtx1800n. put them on by myself in a few hours. would have been faster but had to deal with an exhaust stud that came out and needed to free nut before reinstallation. First purchase from Dennis Kirk, but have already ordered again. Price on this item beat competitors by quite a bit and shipping was simply outstanding.
January 3, 2013
Finish
5 / 5
Performance
5 / 5
Great Big Shot Sound
Installed the exhaust last night. Very easy installation. Need two people to insure its not drop during installation. I listen to the sound on youtube before purchase. it just doesnt give the sound justice. the sound is better than I could have imagined.
January 3, 2013
Finish
5 / 5
Performance
5 / 5
Good fit
Went right on with very little problems. Love the look and the sound. I have been looking for the sound for some time. Very happy with purchase.
March 1, 2011
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Instructions and Manuals for Vance & Hines Big Shots - 18287

You May Also Be Interested In