Need Assistance?
Legendary Service... Ask Your Friends - Since 1969
800.969.7501
Over 160K Powersport Items - In-Stock and ready to ship today! View tires, apparel, helmets, exhaust and more!

Vance & Hines Big Shots - 18411

  • Part #:
    449001
  • Manufacturer Part #:
    18411
Our Price: $699.99
2 on Hand

Overview of Vance & Hines Big Shots - 18411

  • Dramatically increase horsepower and torque
  • Supplied with the Vance and Hines Power Chamber, a unique crossover system that offers all the performance advantages of a 2-into-1 race system
  • Mammoth 2 1/2 in. full-coverage heat shields
  • Removable baffles and racy billet end tips
  • Virtually blue-proof
  • For maximum performance, a Vance and Hines Power Commander is recommended

Included Items:
(2) Nutplates
(2) 6mm Washer
(2) M12 Plug Washer
(1) M10 Lock Nut
(2) M6 Lock Nuts
(1) M10 x 35 Flange Bolt
(1) M10 x 20 Flange Bolt
(2) M12 x 11 Plugs
(2) M6 x 30 Flange Bolts
(4) 5/16 in. Flange Bolts
(5) #20 Hose Clamps
(4) #28 Hose Clamps

Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information.

Installation of a new exhaust system may change your motorcycles fuel-air mixture. Please consult the exhaust manufacturer directly with questions regarding any modifications that may be made during, or after, installing their product. If a jet kit or Power Commander is recommended, see the Intake/Fuel section

Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing, therefore is not covered by any warranty. See Chems/Lubes section for products to help remove or prevent exhaust discoloration.

The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.

Specs for Vance & Hines Big Shots - 18411

Color - Primary Chrome
Finish Chrome
Style Bologna/Slash-Cut Tip
Type 2-Into-2 System
Units Each
Weight 34.00 lbs

Cross reference number(s):

V18411

Specs for Vance & Hines Big Shots - 18411

Color - Primary Chrome
Finish Chrome
Style Bologna/Slash-Cut Tip
Type 2-Into-2 System
Units Each
Weight 34.00 lbs

Fitment for Vance & Hines Big Shots - 18411

See if this part fits your ride

Part 449001 fits the following machines

Honda
  • 2008 Honda VTX1800N
  • 2007 Honda VTX1800N
  • 2006 Honda VTX1800N
  • 2005 Honda VTX1800N
  • 2004 Honda VTX1800N
  • 2007 Honda VTX1800R
  • 2006 Honda VTX1800R
  • 2005 Honda VTX1800R
  • 2004 Honda VTX1800R
  • 2003 Honda VTX1800R
  • 2002 Honda VTX1800R
  • 2005 Honda VTX1800S
  • 2004 Honda VTX1800S
  • 2003 Honda VTX1800S
  • 2002 Honda VTX1800S
  • 2008 Honda VTX1800T
  • 2007 Honda VTX1800T
4.6 / 5.0
24 Reviews
5 Stars
4 Stars
3 Stars
2 Stars
1 Stars
17
6
0
0
1
Finish
4.9 / 5
Performance
4.8 / 5
Finish
4 / 5
Performance
3 / 5
Never Again
I got these pipes for my bike. 12 month(25,000 miles) later, one of the clamps holding the heat shield gave out. Replaced it with a heavier clamp. 1 month later heat shield started rattling again. This time one of the brackets on the heat shield had broken loose. Too the shield off and found that another bracket had broken also. Looking closer I found that every weld on the pipes themselves had failed as well. Called V&H and was told they are out of warranty. Another company has a good set of pipes with a lifetime warranty. 45,000 miles later, they still look and sound like new. V&H? Never again.
September 26, 2009
Finish
5 / 5
Performance
5 / 5
Practice Patience
The look, sound and performance of this exhaust are among the most pleasing on the market. The fitment leaves a lot to be desired. They don't line up withe headers so protect that chrome and grab your pry bar! The plate that mounts the rear of the pipes have mounting holes for the rectifier that need to moved to the right about 1/4 inch so you don't have to re route the wires. Vance Hines should take note these issues as I'm sure it will cost them sales. I can fabricate so I dealt with it although I agree you shouldn't have to. I removed the baffles and cut the fiberglass batting and the end cap off and reinstalled them. I wanted louder. There was no need for fuel management on my VTX 1800 all though they would love to sell it. You may see and hear the finished product by visiting this URL http://www.youtube.com/watch?v=nB_nnSJPhRQ
August 2, 2010
Finish
5 / 5
Performance
5 / 5
Great Pipes
Installed these on my 09 Warrior in about an hour and a half. The fit was a little tight on the front pipe but it all snugged down and sealed fine. Install all mounting hardware loosely and then tighten from front to back. I'm not a fan of chrome but these have an amazing finish and look great. They are very loud on take-off but are mellow at cruising speeds. I'm very satisfied with the look, sound, and quality of the materials and would buy these again. Trouble free shipping as always with Dennis Kirk.
September 4, 2015
Finish
4 / 5
Performance
5 / 5
Big Shots
I purchased these after seeing and hearing them on other V-Star 1300's. They were incredibly easy to install, they look and sound great and they are reasonably priced.
October 14, 2009
Finish
4 / 5
Performance
4 / 5
Vance and Hines Big Shots
These are really nice looking pipes that sound great! You will need some help installing them. They could do a better job bending the pipes to fit.
May 16, 2011
Finish
5 / 5
Performance
5 / 5
Nice but Loud
Have a debaffled Vulcan 1600
Went to these Big shots and Quiet Baffles. considerably louder than the Debaffled Factory pipes.
standard baffles as shipped will make your ears bleed and are simply straight through pies.
Quite baffles added and it is still loud but deeper tone. I like it with the new sound overall.
Fit is good but not perfect. Some tension to install.
Look very nice and 1/2 the weight of stock pipes.
Would buy again
June 14, 2013
Finish
5 / 5
Performance
4 / 5
Big Shots
Easy install, great look, and great sound. All I needed was a large tie wrap to support mufflers, head pipes bolted right up.
August 15, 2015
Finish
5 / 5
Performance
5 / 5
No Review Title Entered By User
One of the best investments that I made for my VTX 1300C. Love the way it looks and sounds. Thanks to Dennis Kirk for fast shipping and good prices.
January 1, 2013
Finish
5 / 5
Performance
5 / 5
Vance&Hines
My vance and hines were installed on a 07 vtx 1300c. You need a little muscle to install but not to hard. I think vance and hines should make a better looking clamp or a chrome cap to cover screw heads. Other than that i'm very pleased. Dennis kirk has fast shipping, and if your like me you want your toy fixed fast.
December 14, 2010
Finish
5 / 5
Performance
5 / 5
Best Pipes I've Had
These pipes are amazing! Was an easy install. Looks and Sounds amazing.
May 31, 2012
Start typing your question and we'll check if it was already asked and answered. Learn More
No questions have been asked about this item. Be the first!

Instructions and Manuals for Vance & Hines Big Shots - 18411

You May Also Be Interested In