NOTE: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and manufacturers information.
(1) 2 into 2 Header
(1) Rear header heat shield
(1) Rear muffler heat shield
(1) Rear bracket
(2) Dog bone nut plates
(5) 2.50 in. Clamps (for V Rod)
(2) 10mm x 1.25 x 25mm Button HCS
(2) M6 x 1.0 Nylock hex nuts
(1) Front Head heat shield
(1) Front muffler head shield
(1) Front bracket
(7) 1.75 in. Clamps (for HD)
(4) 5/16-18 x 5/8 in. Serrated flange bolts
(4) 1/2 x 1 x 3/16 in. Flat washers
(2) M0-1.25 Lock nuts
Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the exhaust manufacturer directly with questions regarding any modifications that may need to be made during, or after, installing their product. If a jet kit or fuel processor is recommended, see the Intake/Fuel section.
Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
|Color - Primary||Chrome|
Part 4404445 fits the following machines