Overview of V-Factor ZZ Top Handlebar - 40028
NOTE: Not for Touring Models 08-up Width: 30 in. Rise: 9 in. Pullback: 5.5 in. End Rise: 7 in. 1 in. Diameter Clamping Width: 5.25 in. Inside Width of Knurling/Outside: 2 1/2 in./4 1/2 in. Drilled for Internal Wiring: Yes Dimpled to Prevent Pinching Control Wires: Yes Three Notches for 08-Up H-D with Electronic Throttle: Yes |
Specs for V-Factor ZZ Top Handlebar - 40028
| Center Width | 7 in. |
|---|---|
| Description | Dimpled/Drilled |
| Diameter - Handlebar | 1 1/4 in. |
| End Rise | 17 in. |
| Finish | Chrome |
| Overall Width - Handlebars | 35 1/2 in. |
| Pullback/Sweep - Handlebars | 9 in. |
| Rise | 17 in. |
| Type | Z & Custom |
| Units | Each |
| Weight | 4.70 lbs |
Specs for V-Factor ZZ Top Handlebar - 40028
| Center Width | 7 in. |
|---|---|
| Description | Dimpled/Drilled |
| Diameter - Handlebar | 1 1/4 in. |
| End Rise | 17 in. |
| Finish | Chrome |
| Overall Width - Handlebars | 35 1/2 in. |
| Pullback/Sweep - Handlebars | 9 in. |
| Rise | 17 in. |
| Type | Z & Custom |
| Units | Each |
| Weight | 4.70 lbs |
Fitment for V-Factor ZZ Top Handlebar - 40028
See if this part fits your ridePart 597443 fits the following machines
5.0 / 5.0
1 Review
Fit
5.0 / 5
Quality
5.0 / 5
Style
5.0 / 5
Value
5.0 / 5
Fit
5 / 5
Quality
5 / 5
Style
5 / 5
Value
5 / 5
Cool Little Bars!
These are some cool little bars, the looked really good on the sportster I put them on, Owner really like them too. Would definitely recommend these bars for a smaller bike or bobber style.
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
August 15, 2013
- Was this review helpful? Yes (0) No (0)
- Flag as Inappropriate
Start typing your question and we'll check if it was already asked and answered. Learn More
Browse 2 questions
Browse 2 questions
and 2 answers
What us rise? It's says 7" and then again at 17". Will it fit 2006 dynamic wide glide
Will they fit a 1200 custom sporster as a direct bolt on?
BEST ANSWER: These bars will fit any motorcycle (Harley) that uses risers that clamp on to a 1" bar (most Jap bikes use 7/8") It'll just bolt right up. The bulk of the bar is 1.25" but not where it clamps and not where the grips go.
- Reply
- Inaccurate
- Robert W on Mar 9, 2017
- Purchased on Jan 5, 2017
