1 1/4 in. o.d. steel handlebars provide a massive look with a style right out of the 50s
Dimpled like 82-later OEM handlebars and slotted under the switch housing area so switch wires can be run internally
Brake side is clearanced to be used with OEM-style master cylinders (all years including 86-later) and most custom brake master cylinders
Knurled at the riser to help prevent slippage
Fit risers mounted on a 3 1/2 in. center
NOTE: Not for Touring Models 08-up
1" diameter clamping width: 5-1/2 in.
Inside Width of Knurling/Outside: 2 1/2 in./4 1/4 in.
Drilled for internal wiring; Yes
Dimpled to Prevent Pinching Control Wires: Yes
Three Notches for 08-up H-D W/Electronic Throttle: No
The quality for the price is great. The welds were clean and the chrome was flawless. The only problem was that it says their dimpled which should allow for you to run wiring externally but the dimples are in the wrong location for a Harley Davidson so your only option is internally which with these bars is difficult and very time consuming. So only buy if your up for the challenge.