2004 Polaris Pro X 800

What was your intended objective when you started the build?

Just to have another older sled.vvvvv

What motivated you to start your project?

Needed another Project. Sleds are my “thing” I like to sink money into.

What was the most unique and creative thing you did to the sled?

The Engine was a pain to figure out! It was blown when i bought. The guy had just put new Ring and piston and jugs on and it went 1 mile and blew again. It had 3245 miles when I bought it in Jan 2016. Motor was a Complete mess!! Carbs where off calibration, Water pump belt was gone missing. You have to pull the motor out of the prox to change that. So not sure why it was missing completely. Took an entire month of ordering new pistons rings, 1 complete new power valve. One new Cylinder, Crank. New seals. new jets, new reeds. list goes on.
I went off what DYNO tech did to there pro X engine so I’m hoping it’s producing 150 hp. It seems to pull good now since i had a winter to test an tune.

What are you most proud of?

That I got it running so good!! And it’s been reliable for an 800.

What do other people say about your sled?

They can’t understand how i see at night time with a red light and it’s creeped some people out.
It’s Like hunting in Texas at night for Hogs. 🙂
I put the LED bulbs in and it’s actually fine at night time.


Leave a Comment

Your email address will not be published. Required fields are marked *

Leave a Comment

Your email address will not be published. Required fields are marked *