Overview of S&S Cycle 510 C Chain Driven Camshaft Kit - 106-4380
- Cams for Dyna 06 and Twin Cam 07-10 are for use with models with hydraulic tensioner chain-drive system; cams 510C are bolt-in applications, all others require high-lift valve springs
- Made in the U.S.A.
Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.
- Designed as bolt-in cam for 88 in., 95 in. and 96 in. engines with compression ratios below 9.7:1
- Intended primarily for stock heads that have not been ported
Duration @ .053: 238 degree
Duration @ .053: 252 degree
(1) Front chain drive cam
(1) Rear chain drive cam
(1) Retaining ring
(1) Large o-ring
(2) Small o-rings
(2) 25 x 32 x 12.5 Needle bearings
(1) 5ml Tube of loctite® 262
(1) 5ml Tube of loctite® 243
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
Specs for S&S Cycle 510 C Chain Driven Camshaft Kit - 106-4380
Cross reference number(s):