Overview of Rigid Industries Radiance Pod Wire Harness - 40300
The Rigid Industries’ Radiance™ Multi-Trigger Harness was designed specifically for the Rigid Industries’ Radiance Pod Set. Equipped with two independent circuits for an easy install, circuit one is designed for the primary LED’s on the Radiance Pod; while circuit two is designed for the backlighting circuit on the Radiance Pod. The Radiance Multi-Trigger Harness also comes standard with two separate backlit LED rocker switches (red and blue), so each circuit can be used independently. The Radiance Multi-Trigger Harness makes installation of your Rigid Industries’ Radiance Pod Set as simple and clean as possible.
Features: •Radiance Multi-Trigger Harness •Integrated Fuse Holder to Protect Both Circuits •Circuit 1 is designed for primary projecting LED’s (same 18awg wire for primary and back-lighting) •Circuit 2 is designed for backlighting circuit. •Two backlit LED rocker switches included for independent on/off of primary LED’s and backlighting. •Three connectors with built in heat shrink ends to be used for splicing in the pigtail.
butt connectors were already crimped to the wires both ends, making them useless for adjusting wirelength. There was no heat shrink included. Hard ware packages had no flat washers required for installation.