One-piece rubber grip with diamond-shaped surface for added grip
Fits over RSI tapered and steel handlebar hooks and other aftermarket pre-bent hooks
Works with hand warmers
Sold in pairs
Width: 34 3/4 in. Rise: 18 in. Pullback: 5 1/2 in. End Rise: 14 1/2 in. 1 1/2 in. Diameter Clamping Width: 8 in. Inside Width of Knurling/Outside: None Drilled for Internal Wiring: Yes Dimpled to Prevent Pinching Control Wires: No Three Notches for 08-up H-D with Electronic Throttle: Yes
These tacky grips are far superior to the standard rock hard rubber race grip that everyone is used to. Although you are not suppposed to use safety wire as it would cut them in half, they have an extremely grippy feel, time will tell how many seasons i can get out of them, I will be rotating them with an air compressor whenever wear appears, so they should last some time.
These are by far way more comfortable than the original BRP grips. Cut old ones off, used compressed air to put these on. Total of a 10 minute job in the end. These feel great on your hands and offer maximum control of your bars. Best part is being able to safety wire them like a MX bike. Can't beat this in value or comfort/style.