Bore Size: Standard
Replacement Ring Set: 13527R
Replacement Wrist Pin: 14450
Replacement Circlips: 14418
NOTE: Dennis Kirk recommends the following preliminary work to be performed by a qualified mechanic prior to installing new pistons. If the old piston has failed, determine the cause and remedy the problem before replacing. Air leaks and/or a lean fuel mixture are the two biggest causes of burned pistons. In cases where any part of the old piston is broken or burned through, the crankcase should be disassembled and throughly flushed of any debris.
NOTE: For replacement standard rings order Part No. 13-527R
NOTE: This single ring piston replaces the two-ring design that was original equipment on some models
Our pistons, rings and kits are sold by application and bore size. Please note that STANDARD and OVERSIZES are not indicated. To get the correct part, you must know the standard bore size to make sure you are ordering either the standard or correct amount of oversize that you need. If you have any questions, please call Technical Service.
|Bore Size||67.72 mm|
|Type||Piston w/Ring Set|
Part 13831 fits the following machines