USB powered from computer (9V adapter no longer needed for programming)
Two-position map switching function built in (map switch not included)
Gear/speed input allows for map adjustment based on gear and speed
Analog input allows user to install any 0-5V sensor and build an adjustment table based on its input such as boost or temperature
With gear-position connected, the PCV is capable of allowing each cylinder to be mapped individually and for each gear
Unit has a -100/ +250% fuel change range (up from -100/ +200%), which allows more adjustment
Ten throttle position columns (up from nine on PCIII USB)
Enhanced "accel pump" utility (increased adjustment and sensitivity range)
Made in the U.S.A.
(1) Power commander module W/wiring harness
(1) 6' USB to mini USB cable
(3) Rubber port plugs
(2) Velcro® pads W/adhesive backing
(1) Alcohol pad
Instructions & manual
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.