USB powered from computer (9V adapter no longer needed for programming)
Two-position map switching function built in (map switch not included)
Gear/speed input allows for map adjustment based on gear and speed
Analog input allows user to install any 0-5V sensor and build an adjustment table based on its input such as boost or temperature
With gear-position connected, the PCV is capable of allowing each cylinder to be mapped individually and for each gear
Unit has a -100/ +250% fuel change range (up from -100/ +200%), which allows more adjustment
Ten throttle position columns (up from nine on PCIII USB)
Enhanced "accel pump" utility (increased adjustment and sensitivity range)
Made in the U.S.A.
(1) Power commander W/wiring harness
(1) 6" USB to mini USB cable
(3) Rubber port plugs
(2) 3/4" x 2" Velcro® pads w/adhesive backing
(1) Alcohol prep pad
(1) O2 Optimizer
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.