Overview of Magnum Custom Sterling Chromite II Designer Series Dual Disc Lower Brake Line - 37005
Revolutionary new concept in aftermarket H-D steel-braided brake lines
One-piece lower line assemblies -- lines are brazed into polished chrome banjo fittings at the caliper end and a polished chrome junction block at the other, so you just bolt the fittings to the calipers and the junction block to the bottom of the triple tree
Lines feature Magnums Sterling Chromite II finish; fittings are polished chrome
Made in the U.S.A.
Included Items: (1) Junction block with three brake lines attached (2) brake lines 19-1/2" with two 10mm banjo (1) brake line 4" with one 90-degree #3 fitting 4) 10mm crush washers
NOTE: Upper and lower lines must be purchased separately (see below for Upper line Part No.'s)
UPPER BRAKE LINE PART NOS.
Upper lines are available in 15 in.-39 in. lengths with 90 degree, 35 degree and 180 straight upper banjo fittings, ensuring a clean, custom look in any application
The fit and finish has to be seen to be believed. Sooo much better than the stock look. Read the little instruction note that comes w/it, on mine I had to remove the stock locating dowel thing. I didn't read the instruction note so I was a bit concerned w/what was up initially. Obviously I used a new upper line also, I'm completely digging the set up, plus it's MADE IN THE USA!!!!!!!!!!!!!
Great Looking product, only thing is, when ordering, be sure to measure & get upper line, since original front dual brake line is a 1 piece assy, neglected that on my part. Other than that, smaller dia. than original, & looks more stylish, works great.
Overall I'm happy with this brake line. I put it on a Victory Touring Cruiser and I have 10mm banjo bolts. Item description states banjo fittings are 10mm. My banjo bolts did not fit, the shoulder on the bolt was too large for the fitting. I used my Dremel to open it up, rinsed vigorously in brake fluid and wiped clean. In the end everything turned out fine with a little extra work.