Magnum Black Pearl Caliber Handlebar Installation Kit for 16 in. Bagger Bars - 48835-216

For models listed w/ABS

• The only complete handlebar kits with matching braided cables and brake lines that include Magnum Caliber 1-1/4” handlebars
• Available in Bagger or Ape Hanger styles for select ABS and non-ABS Harley-Davidson® motorcycles with 12”, 14” and 16” height options
• MAGNUM 1-1/4” Caliber handlebars are manufactured with the highest quality construction, including machined control mounts (not swaged) and feature high luster chrome or gloss black finish for an unsurpassed appearance
• All handlebars are 1-1/4” diameter, have 3-1/2” on center knurling, work with standard controls, including hydraulic clutch, and are machined for internal wiring and electric throttle control
• All Caliber handlebars are preloaded with E-Z pull-thru sleeving to make wiring installations a breeze
• Kits include: Magnum 1-1/4” Caliber handlebars, throttle and idle cables (except 08-15 Dressers and 16 Softail models), a clutch cable or hydraulic clutch line, brake lines, copper crush washers, hardware and wiring extensions
• All cable and brake lines feature either Sterling Chromite® II or Black Pearl braid with highly polished chrome or black chrome plated fittings
• All cables are a low effort, high efficiency design that meets or exceeds all OE specifications for fitment, construction, endurance
• Kits for dual disc models include an all brazed manifold that eliminates leaks, alignment problems, and unattractive threaded connections
• Brake lines exceed all DOT FMVSS-106 requirements
• Made in the U.S.A.

NOTE: Cable and line lengths are based on using 2” risers

(1) Black steel handlebars

(1) Black pearl hydraulic clutch line measures 84" long W/(1) 3/8"/10mm 35-degree banjo fitting and (1) 3/8"-24 inverted flare

(1) Black pearl brake line measures 28" long W/(1) 3/8"/10mm 35-degree banjo fitting & (1) female AN#3 fitting

(1) Black pearl mid line brake measures 53-1/2" W/(1) 12mm banjo fittings & (1) AN#3

(6) 15" Colored throttle by wire wires

(2) 14-1/2" Can-bus harness

(6) 2-1/2" Shrink tubes

(1) 14" Shrink tubes

(4) 3/8"/10mm Copper crush washers

(2) 12mm Copper crush washers

(2) 15" Black cable ties

Instructions

OFF BIKE DIMENSIONS

Width: 35-3/4"                                         

Rise: 16-3/4"                                               

Pullback: 12"                                           

Center width: 12"                                       

End rise: 15-1/4"                                           

1" diameter clamping width: 5-7/8"                         

Inside width of knurling/outside: 2-1/2"/4-1/2"            

Drilled for internal wiring: Yes                       

Dimpled to prevent pinching control wires: No          

Three notches for 08-up h-d w/electronic throttle: Yes