For models listed w/Non ABS
- The only complete handlebar kits with matching braided cables and brake lines that include Magnum Caliber 1-1/4” handlebars
- Available in Bagger or Ape Hanger styles for select ABS and non-ABS Harley-Davidson® motorcycles with 12”, 14” and 16” height options
- MAGNUM 1-1/4” Caliber handlebars are manufactured with the highest quality construction, including machined control mounts (not swaged) and feature high luster chrome or gloss black finish for an unsurpassed appearance
- All handlebars are 1-1/4” diameter, have 3-1/2” on center knurling, work with standard controls, including hydraulic clutch, and are machined for internal wiring and electric throttle control
- All Caliber handlebars are preloaded with E-Z pull-thru sleeving to make wiring installations a breeze
- Kits include: Magnum 1-1/4” Caliber handlebars, throttle and idle cables (except 08-15 Dressers and 16 Softail models), a clutch cable or hydraulic clutch line, brake lines, copper crush washers, hardware and wiring extensions
- All cable and brake lines feature either Sterling Chromite® II or Black Pearl braid with highly polished chrome or black chrome plated fittings
- All cables are a low effort, high efficiency design that meets or exceeds all OE specifications for fitment, construction, endurance
- Kits for dual disc models include an all brazed manifold that eliminates leaks, alignment problems, and unattractive threaded connections
- Brake lines exceed all DOT FMVSS-106 requirements
- Made in the U.S.A.
NOTE: Cable and line lengths are based on using 2” risers
Included Items:
(1) Black steel handlebars
(1) Black pearl hydraulic clutch line measures 84" long W/(1) 3/8"/10mm 35-degree banjo fitting and (1) 3/8"-24 inverted flare
(1) Black pearl brake line measures 31" long W/(1) 3/8"/10mm 35-degree banjo fitting & (1) female AN#3 fitting
(1) Black pearl brake line measures 43-3/4" W/(2) 90-degree banjo fittings & (1) AN#3
(6) 15" Colored throttle by wire wires
(1) 14-1/2" Can-bus harness
(6) 2-1/2" Shrink tubes
(1) 14" Shrink tubes
(8) 3/8"/10mm Copper crush washers
(3) "P" Clamps
Instructions
OFF BIKE DIMENSIONS
Width: 35-1/2"
Rise: 17"
Pullback: 12"
Center width: 12"
End rise: 15"
1" diameter clamping width: 5-7/8"
Inside width of knurling/outside: 2-1/2"/4-1/2"
Drilled for internal wiring: Yes
Dimpled to prevent pinching control wires: No
Three notches for 08-up h-d w/electronic throttle: Yes
|