The wizards at Küryakyn & Kicker have created the ultimate 5-channel motorcycle audio amplifier
4 channels of full range power plus 100 watts of subwoofer power!
Rather than spraying a little car audio amp with some waterproofing goop like the other guys, they started with a clean sheet of paper on this one
DSP, (Digital Signal Processing) provides superior performance when compared to simple car stereo amps
DSP allows the amp to be tuned exactly to the riding environment with equalization, frequency response, & compression all set precisely for rocking on the road
High power combined with low current draw delivers powerful efficient performance without sucking your charging system dry
This is a must have for anyone who demands the most from their motorcycle sound system and wants to add additional speakers
Featuring an ultra slim, compact design, this amp will mount directly inside your bikes factory fairing and has the capability to produce the highest quality sound without over loading or drawing down your bikes charging system. You get to keep the factory radio & its handlebar controls; no need to change out radios!
Specially designed and optimized for Kicker speakers
Max Power Output: 46 w/ch. x 4 @ 2 ohms, (20 Hz-20Khz), 10% THD = 100 w @ 1 ohm, (10Hz -100Hz). 10% THD
Max Current Draw: 26 Amps at 13.8 Vdc
Mounts inside fairing on top of radio on Street glides and Electra Glides
Mounts on side of inside of fairing on Road Glide
Plug & Play wiring included to accommodate for speakers in stock locations
All other Küryakyn speaker kits have wiring to adapt to the Audio Amp harness kits
Designed specifically for use with PART NOS. 40-9013, 40-9230, 40-9243, 40-9244 and 50-8825
NOTE: Will not work with medallion gauges.
NOTE: INSTRUCTION CORRECTION FOR STEP 20: SHOULD READ AS FOLLOWS: Connect the Single Speaker Harness to each front speaker. The right speaker wires are labeled "TO RIGHT FRONT SPEAKER" and are "GRAY". The left speaker wires are labeled "TO LEFT FRONT SPEAKER" and are "WHITE".