Kimpex OEM-Type Piston Assembly - 76.86mm Bore - 09-779-01M
- Dennis Kirk has high-quality, OEM-type piston assemblies to fit most popular snowmobiles
- These pistons more closely match the original equipment in ring design, construction and weight than our other aftermarket pistons
- Its not necessary to replace both pistons in a twin-cylinder engine if you need only one
- All piston assemblies include rings(s), wrist pin and circlips
Bore size: 76.86mm/.40 in. (+1mm Overbore)
Replacement Ring Set: 131437SR
NOTE: FOR STANDARD BORE (75.86mm Bore), ORDER 131436S
NOTE: Dennis Kirk recommends the following preliminary work to be performed by a qualified mechanic prior to installing new pistons. If the old piston has failed, determine the cause and remedy the problem before replacing. Air leaks and/or a lean fuel mixture are the two biggest causes of burned pistons. In cases where any part of the old piston is broken or burned through, the crankcase should be disassembled and thoroughly flushed of any debris.
NOTE: For sleeved, standard sized cylinders, chrome faced rings are recommended.
Our pistons, rings and kits are sold by application and bore size. Please note that STANDARD and OVERSIZES are not indicated. To get the correct part, you must know the standard bore size to make sure you are ordering either the standard or correct amount of oversize that you need. If you have any questions, please call Technical Service.
||Piston w/Ring Set
Alternate/OEM Part Number(s):