Note: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information Included Items: (1) Front headpipe assembly (1) Rear headpipe assembly (1) Front headpipe heatshield (1) Rear headpipe heatshield (1) Front muffler mounting bracket (1) Rear muffler mounting bracket (3) Muffler bracket mount spacers (2) 2-1/2 in. Drag pipe exhaust tips (2) M6-1.0 x 8mm Buttonhead cap screws (2) 6mm External locking star washers (2) 5/16-18 x 3/4 in. Carriage bolts (2) 5/16-18 Hex nuts (2) 5.16 in. Split lock washers (5) #24 Hose clamps (1) Instructions Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the manufacturer directly with questions regarding any modifications that may need to be made during, or after installing their product. If a jet kit or EFI controller is recommended please see the Intake/Fuel section for products available Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by any warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California. |
Finish | Chrome |
---|---|
Mfg #: | 7-2720-01S |
Part #: | 4406220 |
Style | Straight-Cut Tip |
Type | 2-Into-2 System |
Units | Each |
Weight | 23.35 lbs |