This new J&M ROKKER XXRP DSP controlled 4-channel 630 watt RMS fairing/rear speaker amplifier kit has been designed specifically for use on the 2016 Harley® RoadGlide Ultra (NOT for CVO) with the stock Harley radio (NO radio FLASH required).
The specific green-band plug-n-play RCA input harnesses included with this amplifier kit, take the 4-channels of audio signal available from the RoadGlide Ultra version of the Harley Infotainment radio and provides 4 separate channels of amplification at 157.5 watts RMS continuous power per-channel into a 2 or 4-ohm speaker load. (Manually selectable on the amplifier itself for a 2-ohm or 4-ohm speaker load)
This is a full range class D digital amplifier properly shielded against RF interference into the AM or FM stereo radio bands.
These new ROKKER XXRP series amplifiers are fully programmable thru the internal digital signal processor (DSP) and come out of the box already dialed in for this specific RoadGlide Ultra speaker configuration, to provide maximum highway performance from your Harley Davidson audio system.
Should you wish to alter these DSP settings using the internal programming dongle already built into this new amplifier, (USB computer connection cable also included with this amplifier kit) all of our specific custom amplifier programs are now available as a consumer download from the J&M website @ www.jmcorp.com.
Amplifier itself measures 8 1/4” Long X 5 1/8” Wide X 1 5/8” Tall.
(1) 6-1/2" long x 4-3/4" wide x 1-3/4" high AMP with (4) audio connectors, (1) 2 pin male connector and (1) 10 pin male connector
(1) 17-1/2" Red and black wires W/(1) small light and (1) 2 pin female connector
(1) 21" USB cord
(1) 30-1/2" Wiring harness W/(2) 2 pin male connectors and (2) audio connectors
(1) 65-1/2" Wiring harness W/(2) ring terminals, (1) 30 amp in-line fuse and (1) 2 pin female connectors
(12) 7-1/2" Black cable ties
|Ohm Rating||2 ohm|
|Ohm Rating||4 ohm|
|Total Watt Output||157.5w|
Part 4000885 fits the following machines