tough time pounding them on. should have fit better. i,m sure they will be hard to get off when worn. origanals came off easy. for all the trouble, i hope they wear well. also had to drill pilot hole bigger and ream out the hole so the bolt would sit flush. if you dont mind customizing, then buy em. they are a "will fit" not an exact OEM
I ordered the Black Hi performance slides for my 95 zr and could not be happier. Simply had to cut them to the desired length and slide them on! With the graphite additive they produce less friction, which in turn means better durability!!!
Not sure how anyone could rate these as poor if broken in right and hot cold treated to harden them. I installed these before this last riding season. I rode them hard for a mile or so to heat them up and drove into deep snow and stopped to cool them off. I did this a several times when riding for the first time this year. I now have over 2500 miles from this year and there is plenty left for next year if I wanted. Far outlasted my original factory slides. I should easily get next year's riding season out of them. My factory slides only lasted 1100 miles. I put these on my 2011 Crossfire sno pro 800 141"track.
This product was very easy to install, just spray a bit of dry silicone lube on the track rail and these just slide right on. Might have to trim either end but can be done with a hack saw or jig saw or hand saw if you have extra energy
I'm glad I only have the 121" track on my 2003 Skidoo REV... previous sliders/hyfax had to be cut to length.. these I wished were a little longer but I can see that the rear wheel picks up the track before the hyfax tapers down.