Muffler is 23 1/4" long, tip to tip. Installed length will be about 22 1/4" after inserting the headpipe into it
Largest Diameter: 4"
Baffle Description: All-steel, non-removable, not straight through
Channel Mounting Bracket Length: Starts 8 1/8" from inlet end of the pipe
Mounting Strap Dimensions: 1"W x 5"L with mounting holes on 2 1/4"-6 1/4" centers, 1" apart
Mounting Strap Finish Chrome
Has a sticker that says it is intended for pre-83 models and it is not EPA noise legal
Note: Not all products are legal for sale or use on pollution controlled vehicles. Check your local laws and the manufacturers information
Note: Installation of a new exhaust system may change your motorcycles fuel-air mixture requirements. Please consult the manufacturer directly with questions regarding any modifications that may need to be made during, or after installing their product. If a jet kit or EFI controller is recommended please see the Intake/Fuel section for products available
Note: Exhaust discoloration (bluing) is caused by engine conditions such as cam timing, fuel-air mixture, operating temperature, etc. It is not the result of defective manufacturing; therefore it is not covered by any warranty. See the Chems/Lubes section for products to help remove or prevent exhaust discoloration
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
|Color - Primary||Chrome|