Features fuel and timing control, Rev Xtend and is a reduced size from the PCIII USB
Warm-up fuel adjustment (unit reads engine temp and allows fuel/timing adjustments based on the reading)
The Power Commander III USB allowed you to add extra fuel during start-up based on number of revolutions of the engine - Now the easy-to-install Power Commander V reads the exact engine temp through the bikes own ECM, allowing the tuner to choose how much fuel to add
More tuning ranges than PCIII USB
Enhanced accel pump utility
USB powered from computer; 9 volt adapter is no longer needed
Cold starting on heavily modified engines should now be much more controllable and easy to adjust
Software displays J1850 data from bikes stock ECU
Two-position map switching function built in
Can add any SPST switch and toggle between two different fuel/timing maps
Gear/speed input allows for map adjustment based on gear
Analog input allows user to install any 0-5 volt sensor
Build an adjustment table based on analog input such as boost or temperature
Power Commander V is capable of allowing each cylinder to be mapped individually and for each gear with the gear position input connected
Ten throttle position columns
Made in the U.S.A.
The Air Resources Board (ARB) does not permit the use of aftermarket emission-related parts that alter the air/fuel ratio of an emission-controlled vehicle. Due to these legal restrictions this part cannot be shipped to California.
It doesn't just make the bike go faster, it fuels the engine better smoothing out the acceleration all the way through the gears...big difference on my bike- Raider- happy & surprised at the improvement!
This device is very easy to install and the software is incredibly easy to use. It's small enclosure allows easy installation under the seat or in a storage compartment. I also highly encourage the purchase of the Auto Tune module for this unit.
Great product, easy to install, and it definitely lives up to its name, "power commander". The only negative that I would mention is the limited availability of maps. Only three maps were available for my 2012 C50 and they were all based on Vance and HInes pipes with a stock air filter.
power commander is one of the best tuning mods that could be bought, so much can be done with it, and it can be upgraded. the power commander hands down is better then the push button boxes on the market.
The PC V is amazing! My Warrior is moderately modified, and the PC V has smoothed out the power delivery. The PC V makes the fuel injection on my bike run silky smooth. With my modifications and the PC V, I am running close to 90hp and 110 ft-lbs of torq.
The PC V took maybe 10 minutes to install. It took longer taking off the fuel tank than installing the PC V.
Even if your bike is stock or slightly/moderatley/heavily modified; the Power Commander V is a must. I have enjoyed having the PC V on my Warrior.
You also can't beat Dennis Kirk's price on the PC V. Dennis Kirks, price's, customer support, and quick shipping was my final decission in ordering the PC V.
Even though not tested by Dynojet, this works beautifully on the 2008 Victory Vision. Lots of adjustments. Rev extender and can add extra fuel at startup. Coupled with auto tune and i'll be set for life!
2009 roadstar 1700 cobra 2to1 k&nfilter. this simple conf is not on there maps, the software wont run corectly the, shop tunned for 100$ it still acts as if its running out of gass,lean, though my mpg was cut in half. if I could do over I would get the cobra tuner. I will get the auto tune and the backfire secondary air blocker if this works I will add to this review. you cant return this if you open the package.